CONSTRUCTION OF GRAIN GRINDING MACHINE
The aim of the project is to construct a domestic grain grinding machine to be powered by electric motor through pulley and belt transmission.
The project is to perform mostly blending and grinding on grains e.g beans, maize, melon, millet and such other food crops.
In construction of the project, there are various factors that is being put into consideration.
i. The size specification
ii. The power of the electric motor to be used
iii. The domestic operation which can be performed by the machine.
iv. The capacity of the machine.
Table of Contents
Table Of Content
1.1 Research Problem
1.2 Justification Of The Study
1.3 Objectives Of The Study
1.4 Scope And Limitation
2.0 Literature Review
2.1 Existing Grinding Machine
3.0 Description Of The Machine
4.0 Analysis And Size Specification
4.1 Calculation Analysis
5.0 Operation Procedure
6.1 Recommendation For Further Work
Every year, the final year student of this institution in Higher National Diploma (HND) and the National Diploma (ND) into practice.
This is aimed at justifying the emphasis lead on practical work during the course of study in the assigned to construct a grain-grinding machine by the machine committee of Mechanical Engineering Department, the Polytechnic, Enugu.
A grain grinding machine is an equipment used for grinding maize, beans, melon, millet and such other good crops. This equipment comprises essentially of an electric motor, belt, pulley, transmission shaft, hopper, mills, spiral conveyor and stands. These alleviate the rigours and problems house we encounter when grinding beans for the good stuff.
1.1 RESEARCH PROBLEMS
The project research problem are:
i. To construct a local fabricated grain grinding machine using available local technology.
ii. To construct a machine with a size specification.
iii. To construct a machine which can perform a domestic operations.
iv. To construct a machine which have adequate capacity, lighter in weight, lesser fatigue and portable.
1.2 JUSTIFICATION OF STUDY
i. This is to promote indigenous machine and their producers.
ii. To have a portable grain grinding machine constructed for domestic uses with a powered driven source.
iii. To improve the economic and the country as a whole by neglecting imported blenders i.e producing machine that is affordable to substitute the imported blenders.
iv. To be able to meet National Board for Technical Education (NBTE) requirement in awarding National Diploma (ND) in Mechanical Engineering.
1.3 OBJECTIVES OF THE STUDY
The objectives of the study are:-
i. To construct grain grinding machine with local materials.
ii. To construct a machine which is less in crop and domestic usage.
iii. To produce a grain grinding machine that is lesser in vibration, weight and in size.
1.4 SCOPE AND LIMITATION
The following are the scope and limitation of the project:
To construct a machine that can perform domestic grinding of food condiments.
It can perform any operation that the electrical blender can perform due to its electrically powered.
Using this Service/Resources:
You are allowed to use the original model papers you will receive in the following ways:
1. As a source for additional understanding of the subject.
2. As a source for ideas for your own research work (if properly referenced).
3. For PROPER paraphrasing (see your university definition of plagiarism and acceptable paraphrase)
4. Direct citing (if referenced properly)
Thank you so much for your respect to the authors copyright.