Design and Construction of a Single Phase Auto Transformer of Rating 1 KVA 240v/110v 80 12v 6v

ABSTRACT

This project work-up deals on the design and construction of a single phase step down nations former, with raking IKVA, 240V/11OV, 80V 12U, 6V. It is a multi-circuit transformer that has one input as the primary and tappings to produce the output (secondary). It is considered as a single coil in series with the supply and a common coil to the head. It is experimentally done using flat metal shocks of cast steel to form the “E” and “I” shaped laminations and coils of various turns.

Not much progress has been made by those who were in the field in the production of a much circuit auto-transformer. While working this project, we got information from some textbooks on auto-transformer and some expert in the field.

However, the write up goes beyond the perspectives of an ordinary layman’s belief that the theory behind the construction of an auto-transformer cannot be achieved practically by Nigerian Engineers in this country. Every aspect of the auto-transformer.

Table Of Contents

Cover Page
Dedication
Acknowledgements
Abstract

Chapter One

1.0 Introduction
1.1 Background
1.2 Aims Of Study
1.3 The Scope Of Study
1.4 The Auto-Transformer
1.5 Definition Of Terms

Chapter Two

2.0 Literature Review
2.1 Definition And Operation Of Auto-Transformer
2.2 Formulae Of Auto-Transformer
2.3 Components Of Flux In An Auto-Transformer
2.4 Faults In Auto-Transformer
2.5 Losses In Auto-Transformer

Chapter Three

3.0 Construction
3.1 Construction Of The Former
3.2 Methods Of Counting Members Of Turns
3.3 Standard Wire Gauges And Lamination
3.4 Construction Of The Enclosure And Complete Unit
3.5 Testings
3.6 Precautions
3.7 Bill Of Quantities

Chapter Four

4.0 Summary
4.1 Conclusion
4.1 Recommendation
References