DESIGN AND FABRICATION OF WOOD LATHE MACHINE

1286

DESIGN AND FABRICATION OF WOOD LATHE MACHINE

ABSTRACT

This write up outlines the design and fabrication of wood lathe machine. This type of lathe is capable of creating different wood designs using the cheapest available material and method.

To achieve functional and efficient wood lathe of this kind, we analyzed as well as synthesized the different possible design solutions and concepts.

The principle of turner is puts into consideration the case of its production, main finance and services, values durability, reliability and appearance of the machine.

Finally, the parts were assembled and the machine test run. To ensure the achievement of best performance, iterative procedures were carried out. The material, labour and overhead costs were determined to get the production cost of a prototype.

Title Page
Certification
Dedication
Acknowledgement
Abstract
Table Of Contents
Chapter One
1.0 Introduction
1.1 Objectives
1.2 Literature Review
1.3 Trend
1.4 Statement Of Problem
1.5 Purpose Of Study
1.6 Scope Of Work

Chapter Two
2.0 Synthesis
2.1 Theory Of Design
2.2 Materials Selection
2.3 Analysis
2.4 Resolution Of Forces
2.5 Reaction, Force And Moment Digrams
2.6 Maximum Shear And Bending Stresses

Chapter Three
3.0 Assembly Procedure
3.1 Testing And Evaluation
3.2 Operational /Safety Guide
3.3 General Maintenance

Chapter Four
4.0 Cost Analysis
4.1 Material Cost
4.2 Labour Cost
4.3 Overhead Cost
4.4 Summary Of Costs

Chapter Five
5.0 Conclusion
51. Recommendations
References

Get Full Work


Disclaimer:
Using this Service/Resources:
You are allowed to use the original model papers you will receive in the following ways:
1. As a source for additional understanding of the subject.
2. As a source for ideas for your own research work (if properly referenced).
3. For PROPER paraphrasing (see your university definition of plagiarism and acceptable paraphrase)
4. Direct citing (if referenced properly)
Thank you so much for your respect to the authors copyright.