Geophysical Investigation of Abakaliki Area Using Aeromagnetic Method



Aeromagnetic data over Abakaliki area of the lower Benue trough of Nigeria was interpreted qualitatively and quantitatively using Oasis montaj software (version: 6.4.2 H.J).The interpretation unveiled basic intrusive bodies like dyke, lacolyte and batholyte in the study area. It also showed fault zone which trends North East to south western (NE-SW) part of the study area. Quantitative interpretation of the area was carried out by source parameter imaging and forward and inverse modeling. Source parameter imaging unveiled predominance of deep seated bodies in the south western part of the area, while shallow bodies are predominant in the south eastern part of the study area. Depth obtained by source parameter imaging ranged from 99.50m to 5930.78m. Forward and inverse modeling was carried out using potent Q software which is an extension of the Oasis montaj software used in the work. The magnetic anomalies over the area were modeled by bodies in the form of sphere and ellipsoid by varying the total magnetic intensity parameters such as susceptibility, inclination, declination, depth of burial and by varying the length, width and height of the bodies used in the model. The radius of the spherical bodies are 1457m, 17704m and 4883m for models A, B and D representing Obubra, Abakaliki and Ameka respectively. Lengths of the ellipsoids are 6099m and 5341m.Width of the ellipsoids are 411m and 2203m while Heights of the ellipsoids are 6017m and 275m (for models C and E representing Enyigba and Ameri respectively). Depth obtained by forward and inverse modeling ranged from 477m to 6366m. Depth obtained for model A (Obubra) is 546m with susceptibility of 0.0180SI (signifying limestone). Height obtained for model B (Abakaliki) is 50m (likely the out crop near college of Agricultural sciences-CAS EBSU) with susceptibility of -0.0017SI (signifying calcite). Depth obtained for model C (Enyigba) is 956m with susceptibility of -0.0134SI (signifying Rock salt). Depth obtained for model D (Ameka) is 6366m with susceptibility of -0.009SI (signifying Quartz). Depth obtained for model E (Ameri) is 477m with susceptibility of -0.006SI (signifying Calcite). These values correlate with some of the works done in the study area. The presence of out crop, intrusive and minerals like calcite, pyrite, rock salt and limestone were delineated in the area.

Get Full Work

Using this Service/Resources:
You are allowed to use the original model papers you will receive in the following ways:
1. As a source for additional understanding of the subject.
2. As a source for ideas for your own research work (if properly referenced).
3. For PROPER paraphrasing (see your university definition of plagiarism and acceptable paraphrase)
4. Direct citing (if referenced properly)
Thank you so much for your respect to the authors copyright.